MultiModem MTCBA-C Betriebsanweisung PDF herunterladen (Seite 80)

Chapter 3 – Using the Web Management Software

80 MultiModem rCell User Guide

Escape Sequence: Set the escape sequence characters at which the connection terminates.

Inactivity timeout: Set the inactivity timeout at which the connection terminates.

Others: Use to set the other terminating sequences: DTR-toggle or Always-On.

DTR-toggle: If DTR status goes low, the connection terminates.

Always-On: Sets the terminate sequence as Always-on.

Submit Button: Click Submit to save these settings.

Serial Port, Server Settings Parameters

This feature enables a TCP/UDP client on the Ethernet network to connect to the remote serial terminal

connected to the DE9, RS232 port on the router. The router acts as a TCP/UDP server which allows two way traffic

between the TCP/UDP client and the remote terminal on the serial port.

The initial connection setup for the TCP/UDP server is shown in the figure that follows.

TCP/UDP – Server Configuration Group

Configures TCP/UDP Server through which the serial terminal connected to the RS-232 connector, DE9 on the

back of the unit listens for the remote TCP/UDP client to communicate on the LAN/WAN.

Status: Sets the client status to either Enable or Disable. The default is Disable

Server Type: Sets the client to either TCP or UDP. The default is TCP.

Router hardware

TCP/UDP

Server

Serial

Device

DE9

Connector

LAN / WAN

TCP/UDP

Client

HyperTerminal /

Minicom

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Keine Kommentare

MultiModem MTCBA-C Betriebsanweisung Seite 80